| Pin | Wire | Function | Test | Notes |
|---|---|---|---|---|
| 1 | BROWN | INJ1 Injector 1 + | 1.5V - 2.5 Ohms | |
| 2 | BLACK | PG1 Power Ground (Main Relay), A4 | ||
| 3 | RED | INJ2 Injector 2 + | 1.5V - 2.5 Ohms | |
| 4 | BLACK | PG2 Power Ground (Main Relay), A2 | ||
| 5 | LIGHT BLUE | INJ3 Injector 3 + | 1.5V - 2.5 Ohms | |
| 6 | BLUE | PCS Purge Control Solenoid | Coolant Temp > 154F: 12V when activated | |
| 7 | YELLOW | INJ4 Injector 4 + | 1.5V - 2.5 Ohms | |
| 8 | ||||
| 10 | GREEN | Pressure Regulator Cut-off Solenoid | ||
| 11 | BLUE/YELLOW | IACV (EACV) Idle Air Control Valve | 12V to A2, Unplugged 8-15 Ohms | |
| 12 | GREEN/BLACK | FLR1 Main Relay 8 | ||
| 13 | YELLOW/BLACK | IGP1 Injector resistor pack and Main Relay Power | Main Relay 3 | |
| 14 | GREEN/BLACK | FLR2 Main Relay 8 | redundant | |
| 15 | YELLOW/BLACK | IGP2 Injector resistor pack and Main Relay Power | redundant | |
| 16 | BROWN/BLACK | LG2 Logic Ground | Less than 1V at all times | |
| 17 | BLACK/YELLOW | EACV (IACV) Idle Air Control Valve | Dash fuse #14 | |
| 18 | BLACK/RED | LG1 Logic Ground | Less than 1V at all times |
| Pin | Wire | Function | Test | Notes |
|---|---|---|---|---|
| 1 | WHITE/GREEN | VBU Voltage Backup | Hazard Fuse under hood | |
| 2 | ||||
| 3 | YELLOW | ACC AC Clutch Relay | Connect to A18, clutch should click | |
| 4 | ||||
| 5 | ||||
| 6 | GREEN/ORANGE | MIL Malfunction Indicator Light | CEL On when grounded | |
| 7 | BLUE/WHITE | ATSP A/T Shift Position Signal | 5V to A18 | |
| 8 | BLUE/RED | ACS + AC Switch | 5V to A18 | |
| 10 | ORANGE | CKP P Crank Position + (Distributor) | Resistance to C12 350-700 Ohms | |
| 11 | BLACK/GREEN | Rear Defogger Switch (B16) | ||
| 12 | WHITE | CKP M Crank Position - (Distributor) | ||
| 13 | BLUE/WHITE | STS Starter Switch Signal to Main Relay 4 | Engine cranking: 12V | |
| 14 | BLUE | ALT FR Alternator Charging Signal | 5V to A18 | |
| 15 | WHITE | ICM1 Ignition Control Module | 10V to A18 | |
| 16 | YELLOW/RED | VSS Vehicle Speed Sensor (Gauge cluster) | Ignition on, Front wheels rotating: 0 - 5V cycles | |
| 17 | WHITE | ICM2 Ignition Control Module | redundant | |
| 19 | ||||
| 20 | BROWN | Service Check Signal (SCS) Enables Diagnostic mode | Jumpered for Ignition Timing Adjustment |
| Pin | Wire | Function | Test | Notes |
|---|---|---|---|---|
| 1 | BLUE/GREEN | CYP P Cylinder Position + (Distributor) | Resistance to C2 350-700 Ohms | |
| 2 | BLUE/YELLOW | CYP M Cylinder Position - (Distributor) | ||
| 3 | ORANGE/BLUE | TDC P Top Dead Center + (Distributor) | Resistance to C4 350-700 Ohms | |
| 4 | WHITE/BLUE | TDC M Top Dead Center - (Distributor) | ||
| 5 | RED/YELLOW | IAT (TA) Intake Air Temperature | 5V, Sensor resistance (unplugged) 1-4k Ohms | |
| 6 | RED/WHITE | ECT (TW) Engine Coolant Temperature | 5V, Sensor resistance (unplugged) 200-400 Ohm | |
| 7 | RED/BLUE | TPS Throttle Position Sensor | Fully Open: 4.5V, Closed: .3V | |
| 8 | RED/BLUE | SO2S 2nd Oxygen Sensor (B16) | ||
| 9 | RED/WHITE | PA Sensor Atmospheric Pressure (Barometric) Signal | 5V | |
| 10 | GREEN/WHITE | BKSW Brake Switch signal + | Brake pressed: 12V | |
| 11 | WHITE | MAP + Manifold Absolute Pressure | 3V | |
| 12 | GREEN/WHITE | SG2 Sensor Ground (TPS, IAT) | 5V - | |
| 13 | YELLOW/WHITE | VCC2 Sensor Voltage (TPS / PA Sensor) | 5V + | |
| 14 | GREEN/WHITE | SG1 Sensor Ground (MAP) | 5V - | |
| 15 | YELLOW/RED | VCC1 Sensor Voltage (MAP) | 5V + | |
| 16 | WHITE | PO2S Primary Oxygen Sensor |